Clear Packet Counts; Slots 1 To 20 - GRASS VALLEY IQH4B User Manual

Clear Packet Counts

When Clear Packet Counts is clicked, all packet counters will be reset to zero.

Slots 1 to 20

These sections display information about control clients.
Active Front Panels and RollCall PC programs use a RollCall connection to control a module.
RollTrack does not use a connection, it uses Blind Control. Blind Control is the ability to control
a unit without a connection.
56
Note: When SNMP is enabled, generally the first session displayed is the
current SNMP session to that module.
• Disconnect: The Disconnect button will disconnect the currently displayed connected
controller.
• Name: This shows the RollCall controller client name/per session. If SNMP is enabled, one
of the session names corresponds to the name of the Gateway unit.
• Connection: This displays the address of the connected controllers. The Show Session
control can be used to scroll through the connected controllers. If SNMP is enabled, then
the Gateway itself will be shown as one of the controllers, usually the first controller. Packet
counts from this controller, and from all connected controllers, are displayed to the right.
• Blind: This will display the address of last controller to send the module a blind control
packet. Packet counts from blind controllers is shown to the right.
• Allow Blind Control: If the module is to be controlled by Blind Control (RollTrack and
some third party remote control systems), the Allow Blind Control box must be checked.
If Blind Control is not used, Allow Blind Control may be disabled, giving protection
against incorrectly set-up RollTrack sources.
• Single Session Only: When this box is checked, only one connected controller is allowed
to control the module at any one time.