Rollcall Ip; Ip Share Port; Enable Stats; Reset Counts - GRASS VALLEY IQH4B User Manual

RollCall IP

The RollCall IP page reports various statistics about IP share connections and allows
configuration of the IP Bridge function.

IP Share Port

Enable Stats

If Enable Stats is checked, the various packet counters on the page will constantly be updated.
If it is not enabled, these will display a dash (-) instead.

Reset Counts

Click Reset Counts to reset all packet counters to zero.

Show IP Connections in Port Listing

This control is not normally used. Enable it only if instructed to by Grass Valley support.

Pass WAN Packets

• Full Network: The Gateway will accept IP Share connections on this IP port number. The
default is 2050. To enter/modify the full network port number, enter the new number in
the field and click S to save. To restore the default value, click P.
• Local Chassis: This port offers a restricted MAP service, only showing itself. It is used
primarily in complex RollProxy configurations. To enter/modify the local chassis port
number, enter the new number in the field and click S to save. To restore the default value,
click P.
• SP_IAM: If this check box is enabled, then the Gateway will pass wide area I AM messages
received on IP share links to the RollNet network, and over the IP Bridge (if connected).
Note: Pass I_AM (Bridge) overrides both Pass I_AM (Serial) and Pass I_AM
(IP). So if Pass I_AM (Bridge) is set, I AM messages will be passed over the
bridge, irrespective of how the other controls are set.
IQH4B
User Manual
45