Table of Contents
Advertisement
Information Field(s)
Information fields that may be edited by user to specify any information desired. See
of Slot Use
on page 54 for more information.
Information 1
Information 2
For example, these could be used to name signal paths associated per card. Two fields are
available, each allowing up to 19 characters to be displayed.
If these fields have edited values, then a corresponding log field is raised per slot. Log fields are
INFORMATION1= and INFORMATION2=.
Note: A global control for these logging fields is available. See
on page 61 for more information.
These fields are always logged whether a unit is present or not.
Power Usage
This displays the power usage of the module fitted in the slot. See
page 54 for more information.
Power
Slider
When a card powers up in a slot, its rated power is automatically updated in the Power Usage
field.
If a module's ID is not recognized, the power usage will indicate ??. If this occurs, contact Grass
Valley customer service to obtain the correct power usage value.
Some IQ Modular cards do not appear in the port listing (e.g. SDA31/33). In this case, the Non
Rollcall Enable check box should be enabled, and the type added in the IDNAME field.
"B" type chassis (required for new Gateway) report power usage in Load Units (LU).
The power usage reported may be updated if the unit logs a POWER_USAGE log field.
RollCall+ ID
Reports the RollCall+ ID of the module.
Status
Reports current status of the module. Possible values are:
• OK: Module in slot is expected type.
• Absent: Slot configured but no module present.
Preset
Save
RollCall+
Examples of Slot Use
IQH4B
User Manual
Examples
on
53
Advertisement
Table of Contents
