Table of Contents
Advertisement
Ethernet
The Ethernet page enables networking functions to be configured.
Ethernet LAN 1 Primary/2 Secondary
These sections allow static IP details to be set or DHCP to be activated for each LAN interface.
They also report current IP settings and display Traffic/Error statistics.
Setting Static IP Details
Static IP details can be set for primary and secondary LANs, if required. To do this, enter the
appropriate Unit IP Address, Subnet Mask and Default Gateway Address details (available
from local IT support services), and click S to save or P to return to default values.
Click Restart to power-cycle the card and apply the new configuration. DHCP will be
deactivated when the new details are saved.
Activating DHCP
To stop using static IP addresses and use DHCP instead, activate the Enable check box for the
appropriate DHCP LAN, and click Restart.
The new settings will not be applied until the Gateway is restarted.
Traffic/Error Statistics
A range of data detailing traffic through the Gateway and errors detected is displayed to the
right of the Static IP Address Settings pane. Reporting of this data can be switched on or off
via the Enable checkbox.
The various stats counters can be reset to zero by clicking Reset.
44
IMPORTANT - Unit IP Address/Subnet Mask/Gateway Address Defaults
The IQ Gateway ships with the following default settings:
• IP address: 192.168.151.1
• Subnet mask: 255.255.0.0
• Default IP Gateway: 0.0.0.0.
Advertisement
Table of Contents
