Chapter3 Specifications; Performance Specifications - Mitsubishi Electric MELSECQ Series User Manual

3
SPECIFICATIONS
CHAPTER3
3.1
Counting speed switch setting*1
Number of occupied I/O points
Number of channels
Phase
Count input
signal
Signal level ( A,
Counting speed
(max.)*2
Counting range
Model
Counter
Minimum count pulse
width
(Duty ratio 50 %)
Comparison range
Coincidence
Comparison result
detection
Interrupt
5 VDC internal current consumption
Weight
Table 3.2 Relation between rise/fall time and counting speed
Counting speed switch setting
Rise/fall time
t = 1.25 s or less
t = 2.5 s or less
t = 25 s or less
t = 500
Downloaded from ManualsNet.com
SPECIFICATIONS
This chapter describes the performance specifications of the QD63P6, I/O signals to the
programmable controller CPU, specifications of the buffer memory.
For general specifications of the QD63P6, refer to the User's Manual for the CPU module.

Performance Specifications

The following table shows the performance specifications of the QD63P6.
Table 3.1 Performance specifications of the QD63P6
Item
200 k (100 k to 200 kPPS)
B)
(Minimum phase difference for 2-
phase input: 1.25
* 1 Make the counting speed switch setting with intelligent function module switch.
* 2 Counting speed is affected by pulse rise and fall time. Countable speeds are shown in Table 3.2.
Note if a pulse with long rise and/or fall time is counted, a miscount may occur.
200 k
Both 1 and 2-phase input
200 kPPS
100 kPPS
-
-
s
search engine
100 k (10 k to 100 kPPS)
32 points (I/O assignment: Intelligent 32 points)
1-phase input, 2-phase input
5 VDC 6.4 to 11.5 mA
200 kPPS
32-bit signed binary (-2147483648 to 2147483647)
UP/DOWN preset counter + Ring counter function
5
2.5 2.5
(Unit: s)
(Minimum phase difference for
2-phase input: 2.5
s)
32-bit signed binary
Setting value
Setting value = Count value
Setting value
With coincidence detection interrupt function
100 k 10 k
100 kPPS 10 kPPS
100 kPPS 10 kPPS
10 kPPS 10 kPPS
- 500 PPS
Model
QD63P6
10 k (10 kPPS or less)
6 channels
100 kPPS
10
5 5
(Unit: s)
(Minimum phase difference for
2-phase input: 25
s)
Count value
Count value
0.59 A
0.15 kg
t t
3.1 Performance Specifications
1
2
3
4
10 kPPS
100
5
50 50
(Unit: s)
s)
6
7
8
3
- 1