Programming - DAITEM 221-21 Series Manual

4. Programming

IMPORTANT: during recognition
programming, the product to be
programmed for use with the control panel
does not need to be placed next to it. In
fact, we recommend you place the product
at a short distance from the control panel
(at least 2 meters away).
master code
engineer installer
code
IMPORTANT: the control panel indicates
there is an error by emitting 3 short beeps.
When this happens programming should
be carried out again from the start.
4.1 Loop n° 1 programming
Carry out the programming sequence described below:
2. Press &
*
1. Press then # on
hold the
the control panel
"Test"
keypad to move to
button until
programming mode
the control
panel
responds
(see (1) on
next page)
"detector X"
)
)
)
10 sec. max.
or
(depending on configuration)
"beep, remote control X"
then
)
)
2. Press & hold the "Test"
button until the control
panel responds
3. The control panel 4. The control panel
waits for a group
to be chosen from
1 to 8*. Press the
corresponding
digits on the
control panel
keypad to choose
the group
"group?"
*
to
)
10 sec. max.
3. The control panel confirms
programming by issuing a
voice message
5. The control panel
waits for the time confirms
delay to be chosen: programming by
issuing a voice
0: immediate
1: delayed, message
2: combined. Press
"0" or "1" on the
control panel keypad
to choose the group
"time delay?"
"beep, detector X,
group Y, immediate
(or delayed
or combined)"
to
* according
to the model of
the control panel
97