DAITEM 221-21 Series Manual page 98

4.2 Loop n° 2 programming
Carry out the programming sequence described below:
2. Press once
1. Press * then # on
(quickly) and
the control panel
then press
keypad to move to
& hold the
programming mode
"Test"
button until
the control
panel
responds (1)
"detector X"
then
10 sec. max.
or
(depending on configuration)
then
then
2. Press once (quickly) and
then press & hold the
"Test" button until the
control panel responds
(1) • For a technical detector: "Technical detector X"
• For a fire detector: "Fire detector X"
With these 2 applications, there are no steps 3, 4 and 5.
98
3. The control panel 4. The control panel
waits for a group
to be chosen from
1 to 8*. Press the
corresponding
digits on the
control panel
keypad to choose
the group
"group?"
)
)
)
*
to
"beep, remote control X"
)
)
)
10 sec. max.
3. The control panel
confirms programming
by issuing a voice
message
5. The control panel
waits for the time confirms
delay to be chosen: programming by
issuing a voice
0: immediate
message
1: delayed,
2: combined. Press
"0" or "1" on the
control panel keypad
to choose the group
"time delay?"
"beep, detector X,
group Y, immediate
(or delayed
or combined)"
to
* according
to the model of
the control panel
IMPORTANT: during programming, the
LED indicator lamp lights up to show
which loop is being programmed:
• red LED indicator lamp lit: loop n° 1,
• green LED indicator lamp lit: loop n° 2.