Programming - DAITEM 230-21X Installation Manual

2. Carry out the programming sequence described below:
#
*
1. Press then
on the control panel
keypad to move to
programming mode
or
(depending on configuration)
then
* according to the model of the control panel.
2. Press & hold 3. The control panel
the "Test" waits for a group
button until to be chosen from
1 to 8*. Press the
the control
panel corresponding digits
responds (1) on the control panel
keypad to choose
the group
"detector X"
)
)
)
10 sec. max.
"beep, remote control X"
)
)
)
10 sec. max.
2. Press & hold the "Test"
button until the control
panel responds
4. The control panel waits for
the time delay to be chosen:
0: immediate,
1: delayed,
2: combined.
Press "0" or "1" on the
control panel keypad to
choose the
"group?" "time delay?"
*
to
3. The control panel
confirms programming
by issuing a voice
message
5. The control
panel confirms
programming by
issuing a voice
message
"beep, detector X,
group Y, immediate
(or delayed
or combined)"
to
(1) • For a technical detector:
"Technical detector X".
• For a technical detector:
"Fire detector X".
With these 2 applications,
there are no steps 3, 4 and 5.
139