Table of Contents
Advertisement
2.1 Settings
2.1.2 Machine control unit
A new machine control unit is supplied without machine software ex spare parts
warehouse. Following mechanical and electrical installation of the central control unit in
a machine and switching on the key switch, the display will be in an indeterminate state,
since no data has been transferred from the machine control unit to the control panel
(Display: "Loading-Screen"; Service Code: 4.5.2.5.).
Therefore, the machine software must be "flashed" onto the central control unit after
mechanical installation and electrical connection of the central control unit. It is
recommended, to check during every inspection of the machine, if a new software is
available. If so, the new version has to be installed to the control unit.
•
Service PC on which the current Hako diagnostic software is installed. (Windows 10)
•
1 free USB 2.0 port (or higher)
•
CAN-FOX interface PN 03502430
•
Alternatively, the CAN-USB interface PN 03501750
•
Interface cable PN 03502750
Slide 13
Advertisement
Table of Contents
