Flashing The Software - HAKO Scrubmaster B 260 R Service Booklet

2.3 Diagnostics and communication

2.3.5 Flashing the software:

- Turn on the machine.
- Start the Hako diagnostic software. Select the "HAKO" button, then click the
"** B260R" button. The application independently searches for a new, blank
control unit.
- Follow the instructions of the programme. Do not turn off the machine or
disconnect the connection before flashing has been completed.
- Carry out the settings for operative units, options, battery and parameters via the
display according to the training documents.
In the case of a master and slave control (3-brush decks), the flashing of the slave
control is done by the master control. If newer software is available for the slave
control when the machine is switched on (e.g. when a new slave control is installed or
after a software update of the master control), the software of the slave control is
automatically updated. This is displayed in the control panel. Do not switch off the
machine during the update.
Slide 26