Pressure Roller - Novexx Solutions ALX 73 Series Operating Manual

C
LEANING

Pressure roller

WARNING!
Burn hazard! The printhead can become hot
during operation.

Be careful whenever touching the printer.
1. Switch off the machine.
2. Remove the mains power connecting line.
3. Remove the material and ribbon.
4. Remove the bolt [14B] (using 3 mm Allen key).
5. Remove guide section [14A] from side.
6. If printhead does not move into position at far left or
right of printhead axis: Mark position of printhead
on axis.
7. Remove the printhead; see

printheads
on page 7.
8. Wipe off the pressure roller [15A] using a lint-free
cloth and roller cleaner (part no. 98925). Rotate the
roller step for step until it is completely clean.
9. Reinstall the guiding section and fasten it with the
bolt.

Push the guiding section with the groove [16A]
over the rear guide tab on the sensor arm [16B].
10. Reinstall the printhead at its former position.
Operating manual ALX 73x | file version 00 | 04/2011
Replacing
A
[14] Remove the guiding section (A).
A
[15] Position the pressure roller (A) in the printer (guiding section
and printhead removed).
A
[16] Guide tab (B) on the sensor arm.
ALX
73x
GB
B
B
Rubber rollers | 10