Jump Starting; Preparations For Jump Start - RAM Commercial PROMASTER 2022 Owner's Manual

Table of Contents

Advertisement

202
IN CASE OF EMERGENCY

JUMP STARTING

If your vehicle has a discharged battery, it can be
jump started using a set of jumper cables and a
battery in another vehicle or by using a portable
battery booster pack. Jump starting can be
dangerous if done improperly, so please follow the
procedures in this section carefully.
NOTE:
When using a portable battery booster pack, follow
the manufacturer's operating instructions and
precautions.
WARNING!
Do not attempt jump starting if the battery is
frozen. It could rupture or explode and cause
personal injury.
CAUTION!
Do not use a portable battery booster pack or
any other booster source with a system voltage
greater than 12 Volts or damage to the battery,
starter motor, alternator or electrical system may
occur.
P
F
J
REPARATIONS
OR
UMP
The vehicle's jump starting remote posts are
located under the hood, in the engine
compartment on the driver's side.
The Remote positive (+) Post is covered with a
protective cap located on the side of the Front
Power Distribution Center.
The Remote negative (-) Post is located on the core
support closest to the front of the vehicle.
Jump Starting Locations
Remote Positive (+) Post
Remote Negative (-) Post
S
See the following steps to prepare for jump
TART
starting:
1. Apply the parking brake, shift the automatic
transmission into PARK (P) and turn the
ignition to the OFF position.
2. Turn off the heater, radio, and all electrical
accessories.
3. Pull upward and remove the protective cover
over the remote positive (+) battery post.
4. If using another vehicle to jump start the
battery, park the vehicle within the reach of the
jumper cables, apply the parking brake and
make sure the ignition is OFF.
Do not allow vehicles to touch each other as this
could establish a ground connection and
personal injury could result.
WARNING!

Advertisement

Table of Contents
loading

Table of Contents