Table of Contents
Advertisement
34
GETTING TO KNOW YOUR VEHICLE
H
/L
B
S
IGH
OW
EAM
WITCH
With the low beams activated, push the
multifunction lever toward the instrument panel to
turn on the high beams. The High Beam Indicator
Light will illuminate in the instrument cluster to
indicated that the high beams are on. Push the
multifunction lever a second time to switch the
headlights back to low beam. When the ignition is
placed in the OFF position, both the high and
low beams will turn off.
A
H
B
H
UTOMATIC
IGH
EAM
C
— I
E
ONTROL
F
QUIPPED
The Automatic High Beam Headlamp Control
system provides increased forward lighting at night
by automating high beam control through the use
of a digital camera mounted on the windshield.
This camera detects vehicle specific light and
automatically switches from high beams to low
beams until the approaching vehicle is out of view.
NOTE:
The multifunction lever must be in the high
beam position in order for the Automatic High
Beam Headlamp Control to activate.
The Automatic High Beam Headlamp Control
can be turned on or off through Uconnect
Settings Ú page 123.
Broken, muddy, or obstructed headlights and
taillights of vehicles in the field of view will
cause headlights to remain on longer (closer to
the vehicle). Also, dirt, film, and other obstruc-
tions on the windshield or camera lens will
cause the system to function improperly.
When set to AUTO, the system automatically
turns the headlights on or off based on ambient
light levels.
F
-T
LASH
O
EADLAMP
You can signal another vehicle with your headlights
by lightly pulling the multifunction lever toward you.
This will cause the high beam headlights to turn on,
and remain on, until the lever is released.
A
UTOMATIC
To turn on the automatic headlights, turn the end
of the multifunction lever to the AUTO position. To
turn off the automatic headlights, turn the end of
the multifunction lever back to the O (off) position.
P
ARKING
These lights can be turned on, with the ignition in
the OFF position, by moving the end of the
multifunction lever to O (off) position and then to
the headlight position.
-P
ASS
H
— I
E
EADLIGHTS
F
QUIPPED
L
IGHTS
The indicator light in the instrument panel comes
on. The lights stay on until the next ignition cycle is
performed.
H
D
EADLIGHT
ELAY
When this feature is selected, the driver can
choose to have the headlights remain on for a
preset period of time after the engine is turned off.
Activation
To activate the delay feature, place the ignition in
the OFF position while the headlights are still on.
Then, rotate the multifunction lever to the O (off)
position within two minutes. The delay interval
begins when the headlight switch is turned from
O (off) to the low beam position. If the headlight
switch is in AUTO position and headlights were on
before the ignition is OFF, the delay interval begins
automatically.
Deactivation
The feature is disabled by turning on the
headlights, the parking lights or by placing the
ignition in the RUN position. If you shut off the
lights before the ignition is turned on, they will
turn off in the normal manner.
Advertisement
Table of Contents
