Parkview Rear Back Up Camera - RAM Commercial PROMASTER 2022 Owner's Manual

Table of Contents

Advertisement

PARKVIEW REAR BACK UP CAMERA

Your vehicle is equipped with the ParkView Rear
Back Up Camera that allows you to see an
on-screen image of the rear surroundings of your
vehicle whenever the gear selector is put into
REVERSE and/or when the rear doors are opened.
The image will be displayed on the touchscreen
display along with a caution note to "Check Entire
Surroundings" across the top of the screen. After
five seconds this note will disappear. The ParkView
Rear Back Up Camera is located on the top rear of
the vehicle below the center light.
Rear Back Up Camera Location
When the vehicle is shifted out of REVERSE and/or
when the rear doors are closed, the rear camera
mode is exited and the previous screen appears.
When engaged in the REVERSE gear, with the
Camera Delay turned on, the camera image will
continue to be displayed for up to 10 seconds after
switching out of the REVERSE position, unless the
speed of the vehicle does not exceed 8 mph
(13 km/h), or that the gear is placed in the
NEUTRAL or PARK position. When the gear is
no longer in the REVERSE position, on the
radio display, together to the images behind it, a
deactivation button of the image displays on the
camera screen, if Camera Delay is active.
NOTE:
The image displayed on the display may appear
slightly deformed.
When displayed, static grid lines will illustrate the
width of the vehicle and will show separate zones
that will help indicate the distance to the rear of
the vehicle. The following table shows the
approximate distances for each zone:
Distance To The Rear Of
Zone
The Vehicle
Red
0 - 1 ft (0 - 30 cm)
Yellow
1 ft - 3 ft (30 cm - 1 m)
Green
3 ft or greater (1 m or greater)
STARTING AND OPERATING
WARNING!
Drivers must be careful when backing up even
when using the Rear Back Up Camera. Always
check carefully behind your vehicle, and be sure
to check for pedestrians, animals, other
vehicles, obstructions, or blind spots before
backing up. You are responsible for the safety of
your surroundings and must continue to pay
attention while backing up. Failure to do so can
result in serious injury or death.
CAUTION!
To avoid vehicle damage, ParkView should
only be used as a parking aid. The ParkView
camera is unable to view every obstacle or
object in your drive path.
To avoid vehicle damage, the vehicle must be
driven slowly when using ParkView to be able
to stop in time when an obstacle is seen. It is
recommended that the driver look frequently
over his/her shoulder when using ParkView.
NOTE:
If snow, ice, mud, or any foreign substance builds
up on the camera lens, clean the lens, rinse with
water, and dry with a soft cloth. Do not cover the
lens.
107
4

Advertisement

Table of Contents
loading

Table of Contents

Save PDF