Table of Contents
Advertisement
94
STARTING AND OPERATING
T
A
D
URNING
CTIVE
RIVING
O
O
R
FF
Active Driving Assist On/Off Button
To enable the Active Driving Assist system,
proceed as follows:
1. Push the Active Driving Assist on/off button
located on the right side of the steering
wheel. The steering wheel image will display
grey in the instrument cluster display until the
system is engaged. If ACC was previously
turned off, pushing this button will activate
just the lane centering feature of the ADA
system. Push the ACC button to activate both
ACC and ADA Systems.
A
O
2. If ACC was active and engaged before pushing
SSIST
N
the ADA on/off button, ACC will remain
engaged and ADA will become enabled and
then engaged (once all other conditions are
met).
3. If ACC was not enabled before pushing the
ADA on/off button, push the SET (+) button or
the SET (-) button and release when the
desired driving speed is shown in the
instrument cluster display.
4. If desired, adjust the ACC distance setting by
pushing the Distance Setting button.
When all system conditions are met as described
in "System Engagement Conditions" in the next
section, the system will engage and the steering
wheel image in the display will change to green.
Active Driving Assist Engaged (Steering Wheel Green)
NOTE:
Along with the color change of the steering wheel
image, the "glow" effect of the instrument cluster
display will also change to green when ADA is
engaged.
System Engagement Conditions
The following conditions must be met before the
system will engage:
Active Driving Assist system is enabled
ACC is engaged
System detects visible lane markings
Vehicle is traveling below 93 mph (150 km/h)
Vehicle is centered in lane
Turn signal is not activated
Vehicle is not in a tight curve
Driver has hands on steering wheel
Advertisement
Table of Contents
