Auto Unlock Doors; Keyless Enter 'N Go™ - Passive Entry - RAM Commercial PROMASTER 2022 Owner's Manual

Table of Contents

Advertisement

22
GETTING TO KNOW YOUR VEHICLE
A
U
D
UTO
NLOCK
OORS
This feature unlocks all front doors when one front
door is opened.
NOTE:
If the rear or side door is open, only the rear or side
door is unlocked.
Automatic Unlock On Exit Feature
If Auto Unlock is enabled within Uconnect Settings
Ú page 123, this feature will unlock all the doors
when any door is opened if the vehicle is stopped
and in PARK.
K
E
'
G
™ — P
EYLESS
NTER
N
O
E
NTRY
The Passive Entry system is an enhancement to
the vehicle's key fob and a feature of Keyless
Enter 'n Go™ — Passive Entry. This feature allows
you to lock and unlock the vehicle's door(s) without
having to push the key fob lock or unlock buttons.
NOTE:
Passive Entry may be programmed on or off
within Uconnect Settings Ú page 123.
The key fob may not be detected by the vehicle
Passive Entry system if it is located next to a
mobile phone, laptop, or other electronic device;
these devices may block the key fob's wireless
signal and prevent the Passive Entry system
from locking/unlocking the vehicle.
Passive Entry Unlock initiates illuminated
approach (low beams, license plate lamp, posi-
tion lamps) for whichever time duration is set
between 0, 30, 60 or 90 seconds. Passive Entry
ASSIVE
Unlock also initiates two flashes of the turn
signal lamps.
If the vehicle is unlocked by Passive Entry and
no door is opened within 60 seconds, the
vehicle will relock and (if equipped) will arm the
Vehicle Security system.
To Unlock From The Driver, Passenger or Rear
Door
With a valid Passive Entry key fob within 5 ft
(1.5 m) of the door handle, push the Passive Entry
button next to the handle to unlock the vehicle.
Unlock the front doors only if the Uconnect
setting is set to "Approach" and you press the
button located next to the front handle.
Unlock the load compartment doors only if the
Uconnect setting is set to "Approach" and you
press the button located next to the rear handle.
The Passive Entry feature will be disabled if the
Uconnect setting is set to "Off".
NOTE:
Either the load compartment and cabin
compartment or all doors will unlock when you
press Passive Entry button, depending on the
selected setting in the Uconnect system
Ú page 123.

Advertisement

Table of Contents
loading

Table of Contents