Jump Starting - RAM Commercial PROMASTER Cargo Van 2019 User Manual

If the tire pressure is 19 psi (1.3 Bar) or higher:
1. Push the Power Button (1) to turn on Tire
Service Kit and inflate the tire to the
pressure indicated on the tire and loading
information label on the driver-side door
opening.
NOTE:
If the tire becomes over-inflated, push the
Deflation Button to reduce the tire pres-
sure to the recommended inflation pres-
sure before continuing.
2. Disconnect the Tire Service Kit from the
valve stem, reinstall the cap on the valve
stem and unplug from 12 Volt outlet.
3. Place the Tire Service Kit in its proper
storage area in the vehicle.
4. Have the tire inspected and repaired or
replaced at the earliest opportunity at an
authorized dealer or tire service center.
5. Remove the Speed Limit sticker from the
instrument panel after the tire has been
repaired.
6. Replace the Sealant Bottle (4) and Seal-
ant Hose (3) assembly at an authorized
dealer as soon as possible. Refer to "(F)
Sealant Bottle And Hose Replacement".
NOTE:
When having the tire serviced, advise the
authorized dealer or service center that the
tire has been sealed using the Tire Service
Kit.
(F) Sealant Bottle And Hose Replacement:
1. Uncoil the Sealant Hose (3) (clear in
color).
2. Locate the red colored round Sealant
Bottle release button at the lower right
hand corner of the kit.
3. Push and hold the Sealant Bottle release
button, then pull out the bottle holding
the button.
4. Clean any remaining sealant from the Tire
Service Kit housing.
5. Position the new Sealant Bottle (4) in the
housing so that the Sealant Hose (3)
aligns with the hose slot in the front of the
housing. Push and hold the Sealant Bottle
release button, then push the bottle into
the housing by holding the button. An
audible click will be heard indicating the
bottle is locked into place. Release the
button.
6. Verify that the cap is installed on the
fitting at the end of the Sealant Hose (3)
and return the hose to its storage area
(located on top of the housing).
7. Return the Tire Service Kit to its storage
location in the vehicle.

JUMP STARTING

If your vehicle has a discharged battery, it can
be jump started using a set of jumper cables
and a battery in another vehicle or by using a
portable battery booster pack. Jump starting
can be dangerous if done improperly, so
please follow the procedures in this section
carefully.
NOTE:
When using a portable battery booster pack,
follow the manufacturer's operating instruc-
tions and precautions.
95