Uconnect Voice Recognition; If Equipped; Introducing Voice Recognition; Basic Voice Commands - RAM Commercial PROMASTER 2022 Owner's Manual

NOTE:
Do not reposition the head restraint 180 degrees
to the incorrect position in an attempt to gain addi-
tional clearance to the back of the head.
Front Head Restraint Removal
To remove the head restraint, raise it up as far as
it can go. Then, push the adjustment button and
the release button at the base of each post while
pulling the head restraint up. To reinstall the head
restraint, push the adjustment button and the
release button at the base of each post and put the
head restraint posts into the holes. Then, adjust it
to the appropriate height.
NOTE:
Do not reposition the head restraint 180 degrees
to the incorrect position in an attempt to gain
additional clearance to the back of the head.
WARNING!
A loose head restraint thrown forward in a

collision or hard stop could cause serious
injury or death to occupants of the vehicle.
Always securely stow removed head restraints
in a location outside the occupant compart-
ment.
ALL the head restraints MUST be reinstalled in

the vehicle to properly protect the occupants.
Follow the preceding reinstallation instruc-
tions prior to operating the vehicle or occu-
pying a seat.
UCONNECT VOICE RECOGNITION —

IF EQUIPPED

I V
NTRODUCING
Start using Uconnect Voice Recognition with these
helpful quick tips. It provides the key Voice
Commands and tips you need to know to control
your vehicle's Voice Recognition (VR) system.
NOTE:
Voice Recognition is only available on the
Uconnect 5 NAV With 10.1-inch Display.
(Continued)
WARNING!
R
OICE ECOGNITION
GETTING TO KNOW YOUR VEHICLE
B V C
ASIC OICE OMMANDS
The following can be given at any point while using
your Uconnect system.
Push the VR button and after the beep, say a
command. You can also say the system "Wake Up"
word, "Hey Uconnect" or "Hey Ram", and then say
a command. The factory default Wake Up word is
set to "Hey Uconnect" and can be reprogrammed
through the Uconnect Settings. After the beep, say:
"Cancel" to stop a current voice session.

"Help" to hear a list of suggested Voice

Commands.
"Repeat" to listen to the system prompts again.

Notice the visual cues that inform you of your Voice
Recognition system's status.
29
2