Sentry Key; Ignition Switch; Keyless Enter 'N Go™ Ignition - RAM Commercial PROMASTER 2022 Owner's Manual

Table of Contents

Advertisement

16
GETTING TO KNOW YOUR VEHICLE

SENTRY KEY

The Sentry Key Immobilizer System prevents
unauthorized vehicle operation by disabling the
engine. The system does not need to be armed or
activated. Operation is automatic, regardless of
whether the vehicle is locked or unlocked.
The system uses a key fob, keyless push button
ignition and a Radio Frequency (RF) receiver to
prevent unauthorized vehicle operation. Therefore,
only key fobs that are programmed to the vehicle
can be used to start and operate the vehicle. The
system will shut the engine off in two seconds if an
invalid key fob is used to start the engine.
If the Vehicle Security Light is on after the ignition
is placed in the ON/RUN position, it indicates that
there is a problem with the electronics.
CAUTION!
The Sentry Key Immobilizer system is not
compatible with some aftermarket Remote
Starting systems. Use of these systems may
result in vehicle starting problems and loss of
security protection.
All of the keys provided with your new vehicle have
been programmed to the vehicle electronics.
NOTE:
A key fob that has not been programmed is also
considered an invalid key Ú page 270.

IGNITION SWITCH

K
E
'
G
™ I
EYLESS
NTER
N
O
This feature allows the driver to operate the
ignition switch with the push of a button as long as
the key fob is in the passenger compartment.
The START/STOP ignition button has three
operating modes: OFF, ON/RUN, and START.
START/STOP Ignition Button
The push button ignition can be placed in the
following modes:
OFF
The engine is stopped
Some electrical devices (e.g. power locks,
alarm, etc.) are still available
ON/RUN
GNITION
Driving position
All electrical devices are available
(e.g. climate controls, heated seats, etc.)
START
The engine will start (when foot is on the brake)
NOTE:
If the ignition switch does not change the mode by
pushing the button, the key fob may have a low or
depleted battery. In this situation, a backup
method can be used to operate the ignition switch.
Put the nose side (side opposite of the mechanical
key) of the key fob against the START/STOP
ignition button and push to operate the ignition
switch.

Advertisement

Table of Contents
loading

Table of Contents