Table of Contents
Advertisement
After the Active Speed Limiter on/off button has
been pushed, you must press the SET (+) or SET (–)
button to set the target speed (or RES button when
there is already a previously set target).
Push the SET (+) or SET (–) button to raise and
lower the target speed to the desired value.
Pushing and holding down the SET (+) or SET (–)
button will increase/decrease the speed value by
increments of 5 mph (5 km/h).
Each time that Active Speed Limiter is activated, it
will be set to the last programmed value from the
previous activation.
NOTE:
The Cruise Control (if equipped) and Adaptive
Cruise Control (if equipped) systems will be
unavailable while the Active Speed Limiter is in
use.
E
T
S
S
XCEEDING
HE
ET
PEED
By fully pressing the accelerator pedal, the
programmed maximum speed can be exceeded
while the device is active.
In the event that the Active Speed Limiter set value
is exceeded manually with a driver acceleration, an
audible indicator will sound. The indicator light will
rapidly flash, and a message will appear in the
instrument cluster display.
The feature will remain disabled until the vehicle
speed drops below the set Active Speed Limiter
value, where it will reactivate automatically.
D
EACTIVATION
To turn off Active Speed Limiter, push the Active
Speed Limiter button on the right side of the
steering wheel. A message will appear in the
instrument cluster display to confirm that the
feature has been turned off. You can also
deactivate Active Speed Limiter by pressing the
CANC button. In this case, the system is not
completely turned off, and the driver can
reactivate the Active Speed Limiter by pressing the
RES button.
INTELLIGENT SPEED ASSIST (ISA) —
IF EQUIPPED
The Intelligent Speed Assist (ISA) system
combines the Active Speed Limiter and
Traffic Sign Assist (TSA) systems to
automatically adjust the maximum speed
of the vehicle based on detected traffic signs.
A
CTIVATION
To activate the feature, make sure the Traffic Sign
Assist (TSA) system is enabled within Uconnect
Settings Ú page 123, then push the Active Speed
Limiter button located on the right side of the
STARTING AND OPERATING
steering wheel. The message "Ready" will appear
along with a white indicator light in the instrument
cluster display to signal that the system has been
activated.
While the system is in the "Ready" state, the driver
must press the SET (+), SET (–), or RES button to
engage the system. When the system is fully
engaged and detects the current speed limit using
the TSA system, the message in the instrument
cluster display will indicate the new detected
speed limit by suggesting the driver to press
"RES" to accept it.
If the detected speed sign is greater then the
current set speed, an up arrow will be displayed
too. If the detected speed sign is lower then the
current set speed, a down arrow will be displayed
instead. If the driver accepts the new suggested
speed sign, the indicator light will change to green.
Pushing the SET (+) or SET (–) button on the right
of the steering wheel will raise and lower the set
speed to a desired value above or below the set
ISA speed. Pushing and holding down the SET (+)
or SET (–) button will increase/decrease the speed
value by increments of 5 mph (5 km/h).
NOTE:
The Cruise Control (if equipped) and Adaptive
Cruise Control (if equipped) systems will be
unavailable while the ISA system is in use.
79
4
Advertisement
Table of Contents
