Electrical Connections - Vinten FHR-35 User Manual

d a e H t T i l d n a
Installation
Balancing the Head
If the camera moves back towards the horizontal position when
released, the payload is mounted too low—raise the camera cradle.
2.
Tilt the camera cradle through positive and negative angles of
travel, checking that the head remains at the angle of tilt it is set
to, unsupported.
If the camera cradle angle falls or rises, repeat the alignment
procedure until balance is achieved.
3.
After adjusting the C of G height it may be necessary to check that
the fore and aft balance remains satisfactory. Readjust the
position of the camera horizontally on the camera cradle as
required.
4.
After balancing, exercise the head through both axes to confirm
that it operates smoothly.
20
n a P i c o t b o R 5 - 3 R H F

Electrical Connections

CAUTION! Connect the head to the power source using
the attached power cable only. Ethernet cables must be
rated at Cat5e with screened RJ45 connectors.
WARNING! The IEC connector is the primary
disconnect device and must be accessible both during
and after installation of the product.
1.
Connect the lens interface
cable to the lens interface
connector on the FHR-35.
2.
Connect the
power cable
and the
Ethernet cable.