Electrical Connections - Vinten FH155 Manual User Manual

Installation
If the camera moves back towards the horizontal position when
released, the payload is mounted too low—raise the camera cradle.
2. Tilt the camera cradle through positive and negative angles of
travel, checking that the head remains at the angle of tilt it is set
to, unsupported.
If the camera cradle angle falls or rises, repeat the alignment
procedure until balance is achieved.
3. After adjusting the C of G height, it may be necessary to check
that the fore and aft balance remains satisfactory. Readjust the
position of the camera horizontally on the camera cradle as
required.
4. After balancing, exercise the head through both axes to confirm
that it operates smoothly.
16

Electrical Connections

CAUTION! Connect the head to the power source
!
using the attached power cable only . Ethernet
cables must be rated at Cat5e with screened RJ45
connectors .
1. Connect the lens interface
cable to the 26-pin, male
Lens interface connector on
the FH-155.
2. Connect the power cable
and the Ethernet cable.
LANC
GP I/O
LANC
GP I/O
Genlock
source
Genlock
source
Power Out
100-240 VAC
1A MAX.
Power Out
100-240 VAC
Power In
1A MAX.
100-200 VAC
2A; 50-60Hz
Power In
100-200 VAC
2A; 50-60Hz