Electrical System; Assembly - Vinten Vision 8 Maintenance Manual

Contents
11.6 Remove the screw (23) and clamp washer (22) from the end of the pan shaft.
NOTE: The pan drag unit assembly contains 16 cc of Vinten Fluid No. 3. Be prepared to catch any
fluid that may leak from the assembly.
11.7 Tap the exposed end of the pan shaft to separate the spherical base (13) from the pan drag
mechanism.
11.8 Remove the drag actuator block (12) and two drag wedges (11) from inside the spherical base
(13).Remove screw (15) securing the drag shoe assembly (16) to the pan drag housing (8).
11.9 Lift off the pan seal plate (18) and remove and discard the 'O' ring (17) and the omniseal (19).
11.10 Remove two thrust washers (9) and needle thrust bearing (18).
11.11 Wipe all traces of Vinten Fluid No. 3 from components.
11.12 Remove and discard 'O' ring (14) from the shaft in the spherical base (13). If required, remove
bearing (20) from the pan drag housing (8).

Electrical system

12 To remove the components of the electrical system
NOTE: The electrical wiring is secured with hot melt glue. Note the position for reassembly.
12.1 Remove the battery (1).
12.2 Remove three screws (3) securing the PCB mounting (4) to the mechanism housing (2).
12.3 Pull the push-button cap (8) off the switch in the PCB mounting (4).
12.4 The wiring is secured to the mechanism housing (2) using glue. Free the wiring and pull the LED
out of its housing.
12.5 Free the battery connector from the battery housing (9). The PCB and wiring may now be
removed.
12.6 If required, remove the PCB from its housing by separating the upper and lower PCB housings
(5, 6).
12.7 Release the battery housing (9) from the mechanism housing (2) by pushing in the clip.

Assembly

Electrical system
13 To install the electrical system
13.1 Push the battery housing (9) into the mechanism housing (2)
(Fig
(Fig 6.6):
First Previous
Page Page
6.6):
Next Previous
Page View
28