Table of Contents
Advertisement
HS-105P
Electrical Installation And Interconnection
Installation instructions for the controller and associated equipment are provided
in the User Manual for your controller.
1.
Before connecting AC power to any of the equipment, check the labels on
each piece of equipment to make sure that it is the correct voltage for your
installation (i.e. 110 or 220 volts).
2.
Install the rackmount power supplies up to 500 ft. (150 m) from their
respective pan/tilt heads and connect AC power cables.
3.
Connect the power/data cable from each power supply to its pan/tilt head.
4.
Connect the cable from the lens drive assembly to the mating connector on
the HS-105P.
3-10
Installation
User Manual
Advertisement
Table of Contents
