Vinten FHR-35 User Manual page 29

FCC Notice
This product complies with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna
Ÿ
Increase separation between the equipment and receiver
Ÿ
Connect the equipment into an outlet on a circuit different from
Ÿ
that to which the receiver is connected
Consult the dealer or an experienced radio/television technician
Ÿ
for assistance.
FCC Warning
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate
the equipment.
FCC Declaration of Conformity
This product complies with Part 15 of the FCC Rules, Operation is
subject to the following two conditions:
(1) This product may not cause harmful interference.
(2) This product must accept any interference received, including
interference that may cause undesired operations.
FHR-35
V4096-0001
FHR-35 Robotic Pan and Tilt Head FHR-35 Robotic Pan and Tilt Head
General Purpose Connector
The General Purpose Connector can be used to connect a Camera
Control Unit (CCU) or for switching and powering other camera
accessories. The pin outs of the connector are given in the following
table.
CAUTION: Total power drawn from the 12V pins of this
connector must NOT exceed 30W.
Pin No. Description
1 Not connected
2 Aux GND
3 Aux +12V
4 Aux +12V
5 Not connected
6 CCU RXD422
7 CCU RXD232
8 GP I/O 3
9 GP I/O 0
10 GND
11 Aux GND
12 Aux GND
13 Aux +12V
General Notices
Pin No. Description
14 Not connected
15 CCU TXD422
16 CCU TXD232
17 Not connected
18 GP I/O 1
19 GND
20 Aux GND
21 Aux +12V
22 Not connected
23 CCU TXD422
24 CCU RXD422
25 Not connected
26 GP I/O 2
27