Modulex EXT Commercial Series
CHAPTER 4: Installation Instructions
4.6 Boiler Package Contents
In the packaging, in addition to the boiler, you will also find the following contents:
ON THE LEFT HAND SIDE OF BOILER (UNDER PANEL)
•
CSD-1 manifold
•
Relief Valve
CARDBOARD BOX #1
•
Gasket between exhaust manifold and adaptor
•
Four (4) piping elbows, a piping tee, and plastic plug for condensate draining system
•
Hardware for assembling exhaust manifold
•
Three (3) sensors:
o Remote temperature sensor
o DHW Storage tank sensor
o Outdoor temperature sensor
•
Electrical resistor kit for emergency operation
•
Combustion sampling port for the flue
•
Metal plate and cable for power output
CARDBOARD BOX #2
•
European-to-USA vent adaptor
•
Two (2) gaskets for air intake and exhaust connections
•
One (1) 300 mm diameter gasket
INSIDE CASING ON THE BACK OF THE BOILER
•
Two (2) pipes, each 3.3 feet (1 m) long for the condensate draining system
ABOVE THE TOP COVER OF THE BOILER
•
Installation and Operation Manual (OMM) and Ufly Controller Instruction Manual.
IN A SEPARATE BOX
•
Air intake adaptor for spiral ducting only
•
Temperature & Pressure gauge
•
Flow Switch
•
Pipe adaptor (rubber)
OMM-0160_A • DRAFT
Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST
Box #2
Flue Parts
CSD-1
Manifold
Page 25 of 117