Rs-232 Cable; Sma Cable; Power Supply Cable - Altera APEX DSP Development Kit User Manual

APEX DSP Development Kit Getting Started User Guide
20

RS-232 Cable

Attach the serial cable to one of the serial ports on your PC and to the
RS-232 male connector at J7 on the board. See
1
For the APEX DSP board to communicate with the PC via the
RS-232 cable, RS-232 interface logic must be implemented in the
Altera device on the board.
Figure 3. Connect the RS-232 Cable

SMA Cable

Connect both ends of the SMA cable to the APEX DSP development
board. This cable connects the digital-to-analog (D/A 0 and D/A 1) and
analog-to-digital (A/D 0 and A/D 1) connectors on the board.

Power Supply Cable

Connect the power cable to the board as shown in
plug the other end into a power outlet.
After the board powers-up, the EPC16 configuration device, which ships
pre-programmed with a filtering design, automatically configures the
APEX 20KE device. The CONF_DONE LED turns on signifying that the
APEX device is configured.
Getting Started
Figure 3.
Figure 4 on page 21
Altera Corporation
and