Run The Filtering Design - Altera APEX DSP Development Kit User Manual

Getting Started
Figure 4. Connect the SMA Cable
Power
Cable
Run the
Filtering
Design
Altera Corporation
APEX DSP Development Kit Getting Started User Guide
SMA Cable
The board comes pre-programmed with a filtering design. After
connecting the cables to the board, you can run the filtering design.
Additionally, Altera provides a Windows application for the filtering
design that lets you view the unfiltered and filtered signals without an
oscilloscope. To run the Windows application, perform the following
steps:
1. Press push-button SW1 or SW2 to make the user LED 2 (D8) blink,
verifying that the filtering design is loaded into the board.
2. Connect the SMA cable to D/A 1 and A/D 1. See
page 21.
3. Choose Run (Windows Start menu).
4. Click Browse.
5. Browse to the c:\MegaCore\dsp_development_kit-
v1.0.0\labs\filtering\application directory. (If you did not install
the software in the default location, adjust the path accordingly.)
6. Select the file Filter_App.exe.
7. Click Open.
8. Click OK. The Filter_app window opens.
SMA Cable
Figure 4 on
2
21