Renesas 32185 User Manual page 47

Table 2.1 Configuration of the Power Supply
Power
Connector
Supply
CN1 VCC-BUS
CN2 VCCE
— VCCER
— AVCC0
— VREF0
— VDDE
Note1: Case of opened between 1-2, power supply from VCCE is stopped.
Case that 3.3 V power supply is inputted to VCCER by using 3.3 V generated circuit on board, the following items
should be prepared by the user.
- U3: regulator
- D1,D2: diode
- C4,C5: capacitor
Note: The J3, J4, J5, J6 and J7 jumpers are shorted by pattern wiring on the reverse side of printed Circuit board.
Case of setting the condition except for default, setting the jumper is required after cutting the pattern for default
condition by referring to the chapter 3.8 Setting jumper by cutting pattern.
REJ10B0223-0150/Rev.1.50
Jumper
Name Condition
Shorted
between 1–2
J3
Shorted
between 2–3
— —
Shorted
J4
between 1–2
Shorted
J5
between 1–2
Shorted
J6
between 1–2
Shorted
J7
between 1–2
32185/32186/32192/32195/32196 Group
Starter Kit User's Manual M3A-2154G52B
Default Power supply from VCCE (CN2)
Power supply from VCC-BUS (CN1)
— VCCE power supply
Default
Power supply from VCCE
(Note1)
Default Power supply from VCCE
Default Power supply from AVCC0
Default Power supply from VCCE
Mar 2008
Description
Page 39 of 80