Quadratec QuadraTop Adventure Top S Manual page 7

FIG33
Rear Door Surround
Step 7: Installing the Two Center Bows
Locate the second center bow as circled in
FIG31. This bow has a flat bracket welded onto
each end as shown in FIG32.
This bow mounts to the rear Door Surround
knob location. Remove the rear door surround
Knobs from each side of the vehicle and place
the second center bow bracket
This next step is easier and safer if you have a friend helping you. Having a person
NOTICE
on the other side of the vehicle to help lift and locate the front header assembly will
be very helpful.
FIG35
FIG37
FIG39
FIG41
FIG34
hole over the door surround hole (FIG33). Make
sure the bow is rear of the Door Surround Knob.
Line up one side and place the long door su-
rround knob into the hole
securing the center bow (Do not tighten yet)
(FIG34). Go to the opposite side of the vehicle
and line up the holes and place the knob in the
hole. Now tighten each knob securing the bow
to the door surround.
FIG36
FIG38
Front Door Surround
FIG40
7
Bow is towards rear
of V ehicle
Rear Door Surround