Quadratec QuadraTop Adventure Top S Manual page 5

FIG15
FIG14
Step 4: Secure Front & Rear Door Surrounds
to Roll Bar
Locate the two sets of screw knobs in each Door
surround box. There should be (2) sets of three
knobs with two the same length and one shorter
length. The shorter knob attaches to the center
hole on the door surrounds and the (2) longer
knobs go on the front and rear holes.
Line up the door surround "C" attachment holes
with the vertical holes in the roll bar.
Slip the front knob through
Over door bow attached to
windshield header
FIG18
FIG20
Step 5: Attach Quick Release Knobs to Over
Door Bows
Locate the two Quick release knobs and the
header/Deck Assembly shown in FIG 18. You
will be installing one Quick release knob into
each of the over door bow ends. Line up the
quick release knob in the bow end making sure
the knob portion is facing inward and the slot on
the Quick Release knob is vertical, up and down
(FIG 19).
FIG22
FIG16
the hole in the front door surround (FIG14). Ti-
ghten the knob securing the front door surround.
Repeat this procedure on the back of the rear
door surround. Finally, with the short knob secu-
re the "sandwiched" front & rear door surrounds
with the short knob and tighten all three knobs
(FIGs 15 & 16). All knobs on both sides of the
vehicle should be secured to the roll bar.
This completes the installation of the door
surrounds to your vehicle.
Quick Release Knob Knob facing inward
towards center of top
FIG19
FIG21
Using a Phillips head screw driver and the en-
closed set screws, secure the Quick Release
knob to the bow end through the pre-drilled hole
in the bow (FIG 20).
NOTE: If you cannot get the hole started in the
Quick release knob, you may have to drill a
small pilot hole.
Tighten the screw securing the Quick Release
knob to the bow. Repeat on the other side.
FIG23
5
FIG17