Quadratec QuadraTop Adventure Top S Manual page 4

FIG8
FIG9
FIG11
FIG13
Step 3: Install Rear Door Surrounds to Jeep
Locate the assembled Driver's side rear door
surround (Fig 8). On the bottom of the vertical
pillar portion of the assembled door surround is
a pin that will be inserted into the body tub as
shown in FIG9.
On the body tub you may have a rubber seal
that is called out in FIG 10. This seal will
remain on the body tub. Insert the door
surround pin into the
FIG10
FIG12
"C" Attachment
body tub as shown in FIG11. (With the rubber
seal still on the vehicle). After inserting the pin,
locate the upper portion the door surround "C"
attachment and push onto roll bar (Figs12 &
13).
The "C" should fit in the cutout of the roll bar
pad. Line up the threads in the "C" with the top
hole in the roll bar.
Repeat this procedure on the passenger side.
4