Quadratec QuadraTop Adventure Top S Manual page 10

FIG58
FIG60
FIG62
FIG64
Step 11: Installing the Side and Rear Windows
To ensure the top is centered on the vehicle you
will be installing the two quarter windows and the
rear window to the top deck and then to each
other before securing it to the vehicle body.
Pro-Install TIP: To make this as easy as possi-
ble, you may have to release the front windshield
header (release but not un-hook) and keep the
rear corner straps installed in step 10 loosened.
This will allow you to line up all window zippers
and attachments. The rear corner straps and
header will need to be retightened/clamped be-
fore using the top. Locate the drivers rear quarter
window. Line up and slide the rear quarter win-
dow into the "C" Channel as shown in FIG's54,
55 & 56. Repeat this on the passenger side of the
vehicle. Locate the rear window and line up and
slide the rear window into the "C" Channel loca-
ted at the top of the rear portion of the top deck
and slide it across (FIGs57 & 58). Once both
quarter windows and the upper portion of the rear
FIG59
FIG61
FIG63
FIG65
window are secured to the top deck, line up the
driver's side rear zipper on the Quarter window
to the zipper on the rear window and zip
it down a few inches (FIG59). Repeat this on
the pass- enger side of the rear window. You
may have to lift the quarter window up to
secure this second zipper a few inches. Once
both side zippers are attached, zip the rear window
zippers down about a quarter of the way (FIG60).
You will close these zippers completely at the end
of the install.
With the header resting on the windshield
and the over door bows installed, close
the front header latches to secure the front of
the top to the windshield. See FIG's 61,62 &
63 above. With the front header latched,
tighten the rear corner straps making sure
that the top is cen- tered on the vehicle and
the cable/pocket is on the outside of the door
surround (FIG64) and that the cable is
secured under the screw on the door surround
(FIG65).
10