Aligning X-Axes Parallel With Each Other - Festo EXCM-40 Operating Instructions Manual

Assembly
11. Counterhold the adjusting bolt 5 to maintain the alignment.
5
12. Tighten the screw 7. Tightening torque 24 Nm
13. Repeat the previous steps for all adjusting kits.
14. Check the guide rail of X-axis 2 again for compliance with the limit values for height offset to
X-axis 1, flatness and tilt.
Ä X-axis 2 is aligned.
6.4.4

Aligning X-axes parallel with each other

1. Unscrew all screws of the adjusting kits on X-axis 2 in succession one ¼ revolution. Counter hold
the adjusting bolt to prevent it from turning.
2. Slide the Y-axis (cross-brace) back and forth manually over the entire stroke to make the X-axes
parallel.
3. Move the Y-axis (cross-brace) to the motor side. Tighten the screws of the adjusting kit at this
position of X-axis 2. Tightening torque 24 Nm
4. Move the Y-axis (cross-brace) to the next adjusting kit. Tighten the screws of the adjusting kit at
this position of X-axis 2. Tightening torque 24 Nm
5. Repeat the process at all other adjusting kits of X-axis 2.
6. Check both guide rails again for compliance with the limit values for the height offset, flatness and
tilt.
Eliminating warping in the product
NOTICE
Warping in the product
Malfunctions due to increased wear and reduced service life.
• Relieve warping.
Festo — EXCM-40 — 2022-03b
7
19