Measurement Performed With Default-Mode; Measurement Performed In Setup Mode - Festo CP-AM-MEAS Original Operating Instructions

8.3.2 Measurement performed with Default-Mode

The carrier is transported into the CP application module Measuring. It runs through different working
procedures (see sequence description for the Default-Mode and sequence of steps). Afterwards the current
actual measured value of difference is displayed.
The representation on the HMI for the default mode corresponds in the widest sense to the representation in
the MES mode, therefore there is no need to go into that here.
The only difference is:
The MES-order data ONo, OPos and OpNo have no further meaning in the default mode, since the CP
application module Measuring receives the parameter values from the transition table in the default mode.

8.3.3 Measurement performed in Setup Mode

An example for a measurement in the Setup Mode which is within the limit values
1. Place a carrier with pallet and front cover at the stopper position. The inside of the front cover points
upwards. The drill hole of the front cover is on the left side.
2. Define the parameters of the limit values for the actual measured value of difference by clicking on the
input/output field "upper limit value" in the area „Application Parameters" (1). Now a screen keyboard
will appear. Enter the upper limit value on the screen keyboard and confirm. Repeat this procedure for
the lower limit value. Now all parameters required for the measurement have been entered.
© Festo Didactic 8154245 en
Operation
77