Removing The Bearing Cap, Bearing Block And Spindle Assembly With Slide Module - Festo ELGA-BS-KF-70 ML Series Repair Instructions

5. Unscrew the grubscrews in the bearing block and bearing cap.
6. Remove any locking agent residue from the thread.
7. Pull the cover band out of the bearing block, bearing cap and slide module.
8. Pull out the bottom belt reversals on both sides of the slide module.
4.3.2

Removing the bearing cap, bearing block and spindle assembly with slide module

1. Unscrew the socket head screws from the bearing cap.
Note
When the bearing cap is pulled off the cylinder barrel, the bearing seat of
the roller bearing is also pulled off the spindle assembly. After pulling off the
bearing cap the spindle assembly must be supported so that torque / tilting
moments do not damage the roller bearing on the opposite side of the
spindle assembly.
2. Carefully pull the bearing cap off the cylinder barrel.
ELGA-BS-KF-70
3. Unscrew the hex nut from the spindle assembly.
ELGA-BS-KF-80 / 120 / 150
3. Unscrew the slotted nut from the spindle assembly.
22 / 54 Festo 7ELGA-BS-KFa_en