Tools, Equipment, Hardware, And Supplies Required For Installation - Ametek ta7000R User Manual

Tools, Equipment, Hardware, and Supplies
Required for Installation
All connections are made using U.S. standard size connectors.
To install the ta7000R you need the following tools, equipment, hardware, and
supplies:
Open end wrenches
Phillips head screwdriver
Allen keys
Flow Meter (Digital in the SCCM range)
Mirror
Magnet
Detergent-based leak detector
Support gases
Suggested Hardware for Gas Connections
UHP Regulators for Carrier/Sample and Support Gases:
Dual-stage stainless steel, 0–150 PSIG outlet with gauges and 1/16-inch VICI female fittings.
UHP Regulator, Calibration Gas:
One (1), dual-stage stainless steel, 0–150 PSIG outlet with gauges and 1/16-inch VICI fittings.
Adapter, 1/16-inch VICI to 1/4-inch VCR:
Four (4), required for gas connections via 1/16-inch tubing umbilical at regulators,
AMETEK Part No. 220-091.
Nut, 1/4-inch VCR Gland, Male:
Four (4), required for use with VICI–VCR adapters at regulators.
Nut and ferrule, 1/8-inch VICI:
One (1), required for use in connecting the Actuator gas.
Gasket, 1/4-inch VCR, Nickel:
Eight (8), required for use with VICI-VCR adapters.
Tubing, 1/16-inch OD x 0.03-inch ID, Stainless Steel:
Four (4), approximately 72" lengths for gas supply umbilical.
Tubing, 1/8-inch OD, for Pneumatic Line (Actuator gas):
One (1), approximately 72" length for gas supply umbilical.
PN T900-013, Rev A
1/4", 5/16", 3/8", 5/8", 3/4"
1/16", 7/64", 9/64"
Snoop® or another suitable leak detection
agent is permissible.
Installation and Start-Up
|
2-7