Troubleshooting; Error Messages; Detector Controller Error - Ametek ta7000R User Manual

Error Messages are viewed and acknowledged on the System Settings screen.
When the Status LED on the front panel is RED it indicates that there are
system errors or the status of the ta7000R Gas Purity Monitor has changed. The
System Status screen displays error messages that the system has encoun-
tered. From the System Settings screen, check the System Errors area for
error messages (alarms) that have been detected by the ta7000R Monitor.
Figure 4-1.
System Settings screen.

Error Messages

This section lists the Error messages that can be triggered by the system, to
alert you to potential or impending problems with the ta7000R. Descriptions
of the Errors, along with possible trigger conditions, and corrective action to
take to correct the Errors, are also included.
Error Condition / Description / Corrective Action
Chassis Controller Error
Internal electronics failure.
Corrective Action:
Contact AMETEK Service or qualified service representative for troubleshooting assistance.

Detector Controller Error

Internal electronics failure.
Corrective Action:
Contact AMETEK Service or qualified service representative for troubleshooting assistance.
PN T900-013, Rev A

Troubleshooting

Idle Mode
System Settings
Clock: 10-Jan-03
*
Print Chromatograms:
EDL mode:
-------------------- System Errors --------------------
12:34:25
Ver. 2.70
12:34:25
+
+
Edit Print Page
|
Troubleshooting 4-1