Powering Up The Ta7000R Gas Purity Monitor - Ametek ta7000R User Manual

Powering Up the ta7000R Gas Purity Monitor

Adjust incoming gas supply pressures as specified in Chapter 5 – Specifications
(see Inlet Pressure Range).
Power up the ta7000R Monitor by pressing its AC Power Switch (on the Rear
Panel) to the On ("–") position. The Power/Status LED on the front panel will
turn On (GREEN) and the rear cooling fan should begin operating. The initial
start-up screen should appear within a few seconds. If any of these does not
occur, turn the power Off immediately and contact AMETEK Customer Service
or your local authorized service agent.
Figure 2-6.
Initial screen at power-up,
ta7000R Monitor User Interface.
PN T900-013, Rev A
Do not continue with this procedure until the ta7000R Monitor instal-
lation is complete.
Installation and Start-Up
|
2-15