Installing The Optional Optical Drive - Dell PowerEdge R630 Owner's Manual

Figure 40. Removing the optional optical drive
a. optical drive
b. power and data cable
c. release tab
Follow the procedure listed in the After working inside your system section.
Related references
Safety instructions
Related tasks
Before working inside your system
After working inside your system

Installing the optional optical drive

Installing the optional optical drive
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that are shipped with your product.
NOTE: This procedure applies only to the eight hard drive system.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. If installed, remove the optical drive blank.
1. Align the optical drive with the optical drive slot on the front of the chassis.
2. Slide in the optical drive until the release tab snaps into place.
3. Connect the power and data cable to the optical drive and system board.
NOTE: Route the cable properly on the side of the system to prevent it from being pinched or crimped.
Installing and removing system components 91