Before Working Inside Your System; After Working Inside Your System; Recommended Tools - Dell PowerEdge R630 Owner's Manual

Before working inside your system

Follow the safety guidelines listed in the Safety instructions section.
1. Turn off the system, including any attached peripherals.
2. Disconnect the system from the electrical outlet and disconnect the peripherals.
3. If installed, remove the front bezel.
4. If applicable, remove the system from the rack.
For more information, see the Rack Installation placemat at Dell.com/poweredgemanuals.
5. Remove the system cover.
Related references
Safety instructions
Related tasks
Removing the system cover
Removing the optional front bezel

After working inside your system

Follow the safety guidelines listed in the Safety instructions section.
1. Install the system cover.
2. If applicable, install the system into the rack.
For more information, see the Rack Installation placemat at Dell.com/poweredgemanuals.
3. If removed, install the front bezel.
4. Reconnect the peripherals and connect the system to the electrical outlet.
5. Turn on the system, including any attached peripherals.
Related tasks
Installing the system cover
Installing the optional front bezel

Recommended tools

You need the following tools to perform the removal and installation procedures:
● Key to the bezel lock. The key is needed only if your system includes a bezel.
● Phillips #1 screwdriver
● Phillips #2 screwdriver
● Wrist grounding strap
You need the following tools to assemble the cables for a DC power supply unit.
● AMP 90871-1 hand-crimping tool or equivalent
● Tyco Electronics 58433-3 or equivalent
● Wire-stripper pliers to remove insulation from size 10 AWG solid or stranded, insulated copper wire
NOTE: Use alpha wire part number 3080 or equivalent (65/30 stranding).
70 Installing and removing system components