Eight X 2.5-Inch Hard Drive Chassis - Dell PowerEdge R630 Owner's Manual

Table 1. Front panel features of the 10 x 2.5-inch hard drive PowerEdge R630 chassis (continued)
Item Indicator, Button, or
Connector
6 Micro USB port/iDRAC Direct
7 Information tag
8 Hard drives (10)
9 Quick Sync

Eight x 2.5-inch hard drive chassis

Figure 3. Front panel features of the eight x 2.5-inch PowerEdge R630 hard drive chassis
1. Power-on indicator, power button
3. System identification button
5. Optical drive (optional)
7. LCD menu buttons
9. LCD panel
11. Hard drives (8)
Icon Description
Press to toggle the system ID on or off.
If the system stops responding during POST, press and hold
the system ID button for more than five seconds to enter
BIOS progress mode.
To reset the iDRAC (if not disabled in F2 iDRAC setup), press
and hold the button for more than 15 seconds.
Enables you to connect USB devices to the system or
provides access to the iDRAC Direct features. For more
information, see the Integrated Dell Remote Access Controller
User's Guide at Dell.com/idracmanuals. The port is USB
3.0-compliant.
Contains system information such as service tag, NIC, MAC
address for your reference. The information tag is a slide-out
label panel.
Up to ten 2.5-inch hot swappable hard drives. Up to six 2.5-
inch hot swappable hard drives and up to four 2.5-inch Dell
PowerEdge Express Flash devices (PCIe SSDs).
Indicates a Quick Sync enabled system. The Quick Sync
feature is optional and needs a Quick Sync bezel. This feature
allows management of the system by using mobile devices.
This feature aggregates hardware or firmware inventory and
various system level diagnostic and error information that can
be used in troubleshooting the system. For more information,
see the Integrated Dell Remote Access Controller User's
Guide at Dell.com/idracmanuals.
2. NMI button
4. USB management port or iDRAC Direct (2)
6. SD vFlash media card slot
8. Information tag
10. Video connector
12. Quick Sync
Dell PowerEdge R630 system overview 11