Installing The Power Supply Unit Blank; Removing An Ac Power Supply Unit - Dell PowerEdge R630 Owner's Manual

Related tasks

Installing the power supply unit blank

Installing the power supply unit blank
Install the power supply unit (PSU) blank only in the second PSU bay.
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that are shipped with your product.
1. Follow the safety guidelines listed in the Safety instructions section.
Align the power supply unit blank with the power supply unit slot and push it into the power supply unit slot until it clicks into
place.
Figure 67. Installing the PSU blank
a. PSU blank
b. PSU bay
Related tasks
Removing the power supply unit blank

Removing an AC power supply unit

CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that are shipped with your product.
CAUTION: The system needs one power supply unit (PSU) for normal operation. On power-redundant systems,
remove and replace only one PSU at a time in a system that is powered on.
If applicable, unlatch and lift the optional cable management arm if it interferes with the power supply unit (PSU) removal. For
information about the cable management arm, see the system's rack documentation.
Follow the safety guidelines listed in the Safety instructions section.
1. Disconnect the power cable from the power source and from the PSU you intend to remove, and then remove the cables
from the strap.
2. Press the release latch and slide the PSU out of the chassis by using the PSU handle.
Installing and removing system components 121