Vga Module - Dell PowerEdge R630 Owner's Manual

3. Replace the screw that secures the control panel to the chassis.
4. Locate the connectors J_CP and J_FP_USB on the system board.
NOTE: To locate the connectors on the system board, see the Jumpers and connectors section.
5. Connect the control panel cable to the connectors on the system board (J_CP and J_FP_USB) and the hard drive expander
card.
NOTE: Ensure that the control panel cable inside the system is routed along the chassis wall and secured by using the
cable securing bracket.
Figure 92. Installing the control panel for 10 and 24 hard drive system
1. control panel
3. screw hole on the chassis
5. cable securing clip
7. J_FP_USB connector on the system board
Follow the procedure listed in the After working inside your system section.
Related references
Safety instructions
System board jumpers and connectors
Related tasks
After working inside your system
Removing the control panel–10 hard drive and 24 hard drive system

VGA module

NOTE: Only the eight hard drive system has a VGA module on the front panel.
2. screw hole on the control panel
4. screw
6. J_CP connector on the system board
Installing and removing system components 143