Processors And Heat Sinks - Dell PowerEdge R630 Owner's Manual

1. Orient the NDC so that the Ethernet connectors fit through the slot in the back panel.
2. Align the captive screws at the back-end of the card with the screw holes on the system board.
3. To ensure that the connector on the card is in contact with the connector on the system board, press the touch point on the
card.
4. Tighten the two captive screws to secure the NDC to the system board.
5. Install the expansion card riser 3.
Figure 59. Installing the NDC
1. captive screw socket (2)
3. captive screw (2)
5. NDC
Follow the procedure listed in the After working inside your system section.
Related references
Safety instructions
Related tasks
Before working inside your system
Installing expansion card risers
After working inside your system
Removing the network daughter card

Processors and heat sinks

Use the following procedures when:
● Removing and installing a heat sink
2. connector on the system board
4. touch point (2)
6. back panel slots for Ethernet connectors
Installing and removing system components 111