Removing The Vga Module - Dell PowerEdge R630 Owner's Manual

Removing the VGA module

CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that are shipped with your product.
CAUTION: The display module connector is a ZIF (zero insertion force) connector. Ensure that the locking tab
on the connector is released before removal and insertion. The locking tab must be engaged after insertion.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Keep the Philips #2 screwdriver ready.
1. Disconnect the display module cable from the control panel board.
2. Remove the control panel.
3. Disconnect the VGA module cable from the VGA module.
4. Remove the screw that secures the VGA module to the chassis.
5. Slide the VGA module out of the chassis.
Figure 93. Removing the VGA Module
1. screw
3. VGA module
Related references
Safety instructions
Related tasks
Before working inside your system
Removing the control panel–10 hard drive and 24 hard drive system
Removing the control panel–eight hard drive system
Installing the VGA module
144 Installing and removing system components
2. VGA module cable
4. control panel