Figure 44. Removing a cooling fan
1. cooling fan (7)
2. connector on the system board (7)
Related references
Safety instructions
Related tasks
Before working inside your system
Installing a cooling fan
Installing a cooling fan
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
NOTE:
The procedure for installing each fan is identical.
1. Align the connector at the base of the cooling fan with the connector on the system board.
2. Slide the cooling fan into the securing slot until the tab locks into place.
Follow the procedure listed in the After working inside your system section.
Related references
Safety instructions
Related tasks
Before working inside your system
After working inside your system
Removing a cooling fan
Internal USB memory key (optional)
An optional USB memory key installed inside your system can be used as a boot device, security key, or mass storage device.
To boot from the USB memory key, configure the USB memory key with a boot image and then specify the USB memory key in
the boot sequence in System Setup.
The internal USB port must be enabled in Internal USB Port option in the Integrated Devices screen of System Setup.
NOTE:
To locate the internal USB port J_USB_INT on the system board, see the System board jumpers and connectors
section.
Installing and removing system components
95