Table of Contents
Advertisement
⚠ ⚠ ⚠ ⚠
Reducing the risk of splashing:
Reducing the risk of splashing:
Reducing the risk of splashing:
Reducing the risk of splashing:
1) Avoid holding the vessel that you are filling too far away or
close from the spout exit. We recommend around 5-10cm
(2-4"). Start with the cup closer to the spout exit.
2) Tilt the cup slightly to reduce the splashing from the base
of the cup.
⚠
Eliminate backflow contamination:
As your mixer tap has multiple waterways, as with all taps it is
important to eliminate the risk of back flow contamination in
waterways.
1) Always respect the minimum gap shown between the
spout exit and the vessel being filled.
2) Never use 98° water simultaneously with any other water
source.
To get
To get the
To get
To get
the
the best results:
the
best results:
best results:
best results:
Each time the product is used you should flush a small amount of boiled water through before use. This ensures
fresh water is dispensed, typically this can be used to preheat your cup. If unused for extended periods, then flush the
product for a longer time (see section periods of non use).
PROBOIL.4E user & installation guide v1d
If two hands are needed (to hold a larger
pan for example), first move the spout over the
sink bowl, then the Hotkey can be leaned against
the front of the tap instead as shown.
Start with the pan in both hands and closer to
the spout exit until it has a small volume of water
in the base, then if the pan becomes
uncomfortably heavy place the pan on the
drainer, remove the hotkey, rotate the spout
towards the pan then replace the hotkey to fill
the pan further. Once filled remove the hotkey
before removing the pan.
⚠
Always exercise due care when handling
larger volumes of hot water.
5cm / 2" (Min.)
10cm / 4" (Max.)
8
Advertisement
Table of Contents
