Table of Contents
Advertisement
You may also consider closing your mains stop cock to prevent flood damage from any of the water using appliances and
pipes in your household (as generally advised by insurers, each home will have individual requirements check first with
your plumber if you are unsure).
Upon returning after an extended period of absence with the boiler power off you must re-sanitise the boiler and
connections by following the steps below.
1.
Turn on the water supply (if previously isolated)
2.
Turn on the boiler but leave it in standby mode (boiler screen does not display temperature)
3.
Dispense the entire contents of the boiler using the hotkey as normal until the heated water stream is entirely cold
then allow it to continue to run for a further 5 minutes.
4.
Turn on the standard cold tap on and run this for 5 minutes (not simultaneously with the boiler water)
5.
If your tap has a cold filtered water function (4 in 1 taps only) run the cold filtered water for 1 minute.
6.
Turn the boiler on using the standby key (boiler screen now displays the temperature)
7.
Adjust the boiler temperature to 98°C using the "+" key
8.
Wait for the boiler to display "READY"
9.
Wait a further 10 minutes
10. Adjust the temperature to your final desired setting using the "+" and "-" keys
11. dispense 4 litres of boiled water using the Hotkey (approximately 4 minutes)
12. Allow the boiler to reheat fully and display "ready" before use
⚠
For very long extended periods of non-use please also refer to section "Cleaning and sterilising the PROBOIL
system internal tank"
Aesthetic c
Aesthetic c
Aesthetic c
Aesthetic cleaning
leaning
leaning
leaning
Use of any cleaners with acids, abrasives, alkaline or organic solvents, on any part of the product
can result in deterioration of the components and will void the warranty. Clean the product only with
a mild dish soap and a damp non-abrasive cloth. Separate care information for the tap is provided
with your tap installation instructions.
⚠
WARNING
Do not use any excess water or steam jet when cleaning this appliance.
:
⚠
WARNING
Cleaning and user maintenance shall not be performed by children without
:
supervision.
⚠
WARNING
Disconnect the appliance from the power outlet before cleaning, allow the product
:
to cool before cleaning and take care of any surfaces or components that may still be hot.
You should ensure the boiler is and tap aerator are both free of limescale to ensure continuous
safe and energy efficient usage of this product. Advice on sterilisation and descaling are covered
separately within this guide.
PROBOIL.4E user & installation guide v1d
10
Advertisement
Table of Contents
