Install The Tap - PROBOIL .4E User's Installation Manual

2.3.2 Install the tap

⚠
YOU MUST INSTALL THE TAP FIRST BEFORE COMMENCING THE BOILER INSTALLATION

Installation of the tap will vary from model to model, you must now refer to the separate installation guide
supplied with the tap or dispenser at this time.
1) Install the tap as per the model specific guidelines supplied with each tap connect the domestic cold (and hot if
applicable) water inputs to the tap.
2) Check you have the right hoses attached to the right inlets and outlets of the tap, you can quickly do this by very
slowly part opening the operating handle(s) to an on position and checking for output being out of the expected
hose into a bucket or similar.
⚠
With all handles in the off position, blow through the tap boiled water hose (X5). If connected correctly air
should pass freely to the centre spout channel.
PROBOIL.4E user & installation guide v1d 34